Fenix Support logo
Fenix Support logo

All articles

Fenix LD36R FAQs

Fenix LD36R FAQs

Fenix LD36R FAQs

What kind of LEDs are used in LD36R?

3 x Luminus SFT25R Gen2 LEDs and 3 x high-performance RGB LEDs with a lifespan of 50,000 hours each.

What is the color temperature of the LD36R's white output?

Around 6500K.

Is LD36R rechargeable? How long is the charging time?

Yes, LD36R is rechargeable with an inner waterproof USB Type-C port. While charging, please follow the steps below: Turn off the flashlight and open the anti-dust cover to reveal the USB Type-C charging port, then connect the USB Type-C end of the...

What is the working voltage and the working current of LD36R?

The working voltage is 3.0 V - 4.2 V and the maximum working current is 12 A.

What is the runtime of the Turbo output?

The runtime of the Turbo output is 3 hours 41 minutes. However, the light will accumulate a significant amount of heat used at Turbo output. When the light reaches a certain temperature, the light will automatically step down a few lumens to reduce t

How to prevent accidentally activating the LD36R?

Turn off and lock the flashlight or take out the battery to prevent accidental activation during storage or transportation.

What are the optional accessories for the LD36R?

The package comes with a lanyard, a holster, and an AOD-04 diffuser tip. Compatible accessories include: AOF-L filter adapter, AOT-04 traffic wand, AOD-M diffuser tip, etc.

Why does the LD36R downshift to a lower mode after being used for a while and the higher mode cannot be selected?

There are two reasons:. 1. Intelligent Overheat Protection. The flashlight will accumulate a lot of heat when used at high output levels for extended periods. When the light reaches a temperature of 60°C or above, the light will automatically step do

Why does the LD36R sometimes flicker?

The reasons that may cause the light to flicker, shine intermittently or even fail to illuminate:. 1. Poor battery level. Solution: Recharge or replace the battery. 2. The contact or contact point of the battery or light is dirty. Solution: Clean the